Wire & Tube Cutting Jig

Move the Stop up or down the 6" Jig body and screw down the knurled knob to set the length of wire or tubing for your project. A 2mm setback in the V Channel Insert allows a smaller gauge wire to slide under the Stop and not slip up when the wire is cut. Use the saw guide left or right handed by unscrewing the Thumbscrew and inserting it into the Saw Guide from the opposite end. Rotate the Saw Guide with the V Channel on top and screw the Thumbscrew into the Jig, lining up the Stabilizing Plug in the adjacent hole. Remove the Saw Guide entirely to flush cut wire.

For Hands free use screw through the beveled hole in the upper left of the Jig and into your bench top. Or remove one of the screws from the Aluminum surface of your Jayne Redman® Rotational Bench Pin. Use it to screw directly through both the beveled hole in the upper left of the Jig and the Aluminum Surface into the Rotational base. The Wire and Tube Cutting Jig can also be attached to the WorkRing of your Jayne Redman® Rotational WorkRing System. Screw a 1/4" Phillips head screw through the beveled hole in the jig and into one of the threaded holes in the WorkRing. Screw a 1/2" Phillips head screw into a threaded hole next to the Jig to clamp it in place.