The Jayne Redman® Wire and Tube Cutting Jig is the perfect tool for hands free cutting of a wide range of materials and dimensions. Move the Stop up or down the 6″ Jig body and screw down the knurled knob to set the length of wire or tubing for your project. A 2mm setback in the V Channel Insert allows a smaller gauge wire to slide under the Stop and not slip up when the wire is cut. The backside of the V Channel does not have a setback. To use the flush side of the Jig, slide the Stop off the Jig and rotate so that the knurled knob is on the left. Slide the Stop back on the Jig. You will now be able to slide the Stop down the entire length of the jig to cut smaller gauge wire or tubing less than 2mm long.
Use the saw guide left or right handed by unscrewing the Thumbscrew and inserting it into the Saw Guide from the opposite end. Rotate the Saw Guide with the V Channel on top and screw the Thumbscrew into the Jig, lining up the Stabilizing Plug in the adjacent hole. Remove the Saw Guide entirely to flush cut wire.
For Hands free use screw through the beveled hole in the upper left of the Jig and into your bench top. Or remove one of the screws from the Aluminum surface of your Jayne Redman® Rotational Bench Pin. Use it to screw directly through both the beveled hole in the upper left of the Jig and the Aluminum Surface into the Rotational base.
Go to Shop Tools for more information.
